Read More>

Vapor Compression Refrigeration System：It is the most widely used refrigeration cycle to use the latent heat produced by the phase change of working medium to realize refrigeration through the closed cycle of compression, condensation, throttling and evaporation. Compressor: absorb the refrigerant v   Read More>

Introduction to Refrigerated ContainerWith the continuous improvement of the quality of life, people's requirements for food freshness are gradually increasing. Refrigerated container can solve the problem of food loss in the long-term transportation process, and ensure the freshness of vegetables,   Read More>

The principle of combined cold room is to divide a set of cold room into two single rooms with different temperatures, and install two doors respectively. According to the needs of food storage, the combined cold room can design different temperatures, and can also achieve the functions of chiller a   Read More>

Meat products are mainly divided into beef, mutton, poultry and so on. When the temperature of meat cold room is -18 ℃, the freshness of meat can be guaranteed. At the same time, it can prevent fat oxidation and bacterial reproduction at this temperature. They need to be stored under the correspondi   Read More>

1. The frost on the surface of the evaporator is too thick or too much dust. Because of the decrease of the heat exchange effect, the temperature of the room decreases slowly.2. Due to the poor heat insulation or sealing performance of cold room, the cooling capacity loss is large. The thickness of   Read More>

The air cooler is a kind of evaporators used in refrigeration equipment of cold room. Its principle is that the liquid refrigerant with low temperature and low pressure vaporizes on one side of the evaporator heat transfer wall to absorb heat, so that the medium on the other side of the heat transfe   Read More>

Important Points for Attention in Cold Room Design1. Cold room design needs to reserve space for expansionThe scale and layout of cold room should be determined reasonably. Especially when cold room is built for the first time near the wharf and water and land transportation hub, there should be ro   Read More>

How to prolong the service life of refrigeration equipment after cold room installation? Today, Linble would like to share some notes on the maintenance of cold room.1. In the initial operation of the refrigeration unit, the lubricating oil condition of the compressor should be often observed. If th   Read More>

In order to solve the problem of food preservation and quality assurance, cold storage is a very good way. Because of its advantages and low cost, more and more people want to build the cold storage witch use aluminum tubes. Today, Linble Cold Chain will share the construction advantages of aluminum   Read More>